Splash and Sludge Stopper

Features

Splash and Sludge Stopper will keep your water feature looking beautiful all year round. Reduce water tops up and boring cleaning by adding Splash and Sludge Stopper to your water feature monthly.

The most common cause of water loss in water features is through splash, meaning you may need to top up your water feature daily. With Splash and Sludge Stopper, topping up is hugely reduced, giving you more time to enjoy your water feature.

Splash and Sludge Stopper will also reduce the need for manual cleaning, helping to remove sludge and dirt.

Reduces splash and saves water

Cleans sludge and dirt

Treats 12 gallons (45 litres)

For use on resin, stone and concrete fountains

How to use

Use when:
Fountains frequently need to have water added
Fountains are dirty and contain sludge

Splash and Sludge Stopper is toxic to aquatic life and should only be used in self-contained fountains that do not support aquatic life.

How to use:
First Application: Clean and fill your fountain. 1 level inner capful treats 2.1 US gallons (8 litres). Don’t overdose. NOTE: it takes 24 hours to dissolve
We would advise sprinkling the treatment over the water surfaces, rather than in one spot, to help it dissolve

Top up dose: If the fountain starts splashing again, top up with water and add ¼ dose of first application

Monthly: Flush your fountain and add a first application dose. Don’t add more than two full doses without flushing the fountain with fresh water.

Store in a cool dry place.

Warnings:

Toxic for aquatic life.

Keep out of reach of children

Keep away from heat and sources of ignition